Effect of Nano Nd2O3 on the Wear Resistance and High Temperature Oxidation Resistance of Micro-Arc Oxidation Coating on TC11 Titanium Alloy

CHENG Zhaohui, YANG Wei, ZHANG Yong, SHI Xiaoqian, RAO Mosong

doi:10.16577/j.issn.1001-1560.2023.0159

2023 , Vol. 56 >Issue 7: 38 - 46

DOI: https://doi.org/10.16577/j.issn.1001-1560.2023.0159

Effect of Nano Nd₂O₃ on the Wear Resistance and High Temperature Oxidation Resistance of Micro-Arc Oxidation Coating on TC11 Titanium Alloy

Expand

School of Materials and Chemical Engineering，Xi’an Technological University，Xi’an 710021，China

Received date: 2023-02-03

Revised date: 2023-03-02

Accepted date: 2023-04-01

Online published: 2023-08-23

Fold

Abstract

In order to improve the wear resistance and high temperature oxidation resistance of TC11 titanium alloy，Nd2O3 particle-doped micro-arc oxidation coatings were prepared by adding different concentrations of Nd2O3 particles.The effect of Nd2O3 concentration on the microstructure and phase composition of micro-arc oxidation coatings on TC11 titanium alloy was studied by scanning electron microscope and X-ray Diffractometer.Meanwhile，the wear resistance and high temperature oxidation resistance of the coating was evaluated.Results showed that after adding Nd2O3 particles，the number of micropores on the surface of the coating decreased，and the coating phase was mainly rutile TiO2 and anatase TiO2.With the increase of Nd2O3 concentration，the content of Nd element in the coating gradually increased，and the coating thickness first increased and then decreased.When the concentration of Nd2O3 was 1 g/L，the comprehensive performance of the prepared micro-arc oxidation coating was the best，which possessed the average thickness of 8.68 μm，the wear loss of 0.43 mg，the wear scar width of 598.04 μm，and the high temperature oxidation weight gain of 0.139 mg/cm2.Compared with the TC11 titanium alloy and the sample without adding Nd2O3 particles，the high temperature oxidation resistance of the micro-arc oxidation coating was significantly improved after adding 1 g/L Nd2O3 particles，and the wear resistance decreased compared with that without adding Nd2O3 particles.

Key words： TC11; micro-arc oxidation; Nd₂O₃particle; wear resistance; high temperature oxidation resistance

Cite this article

CHENG Zhaohui, YANG Wei, ZHANG Yong, SHI Xiaoqian, RAO Mosong . Effect of Nano Nd₂O₃ on the Wear Resistance and High Temperature Oxidation Resistance of Micro-Arc Oxidation Coating on TC11 Titanium Alloy[J]. Materials Protection, 2023 , 56(7) : 38 -46 . DOI: 10.16577/j.issn.1001-1560.2023.0159

References

[1] 颜家杰，高德峰，廖宇辰，等.钛合金在新型水下航行器上的应用研究进展[J].兵器装备工程学报，2022，43(7):52-57.YAN J J，GAO D F，LIAO Y C，et al.Application research progresses of titanium alloys in new type of underwater vehicles[J].Journal of Ordnance Equipment Engineering，2022，43 (7): 52-57.

[2] 梁顺星，刘凯洋，尹丽霞，等.高强韧异质钛合金的研究进展[J].特种铸造及有色合金，2022，42(2):138-143.LIANG S X，LIU K Y，YIN L X，et al.Progress in Heterogeneous Titanium Alloys with Extraordinary Strength and Ductility[J].Special Casting and Nonferrous Alloys，2022，42 (2): 138-143.

[3] 崔振铎，朱家民，姜辉，等.Ti 及钛合金表面改性在生物医用领域的研究进展[J].金属学报，2022，58(7):837-856.CUI Z D，ZHU J M，JIANG H，et al.Research Progress of the Surface Modification of Titanium and Titanium Alloys for Biomedical Application [J].Acta Metallurgica Sinica，2022，58 (7): 837-856.

[4] 黄张洪，曲恒磊，邓超，等.航空用钛及钛合金的发展及应用[J].材料导报，2011，25(1):102-107.HUANG Z H，QU H L，DENG C，et al.Development and Application of Aerial Titanium and Its Alloys[J].Materials Reports，2011，25 (1): 102-107.

[5] SHI H L，LIU D X，ZHANG X H，et al.Effect of pre-hot salt corrosion on hot salt corrosion fatigue behavior of the TC11 titanium alloy at 500 ℃[J].International Journal of Fatigue，2022，163: 107055.

[6] 陈艳娜，熊毅，范梅香，等.TC11 钛合金在不同温度下的疲劳断裂分析[J].材料热处理学报，2019，40(8):61-68.CHEN Y N，XIONG Y，FAN M X，et al.Fatigue fracture analysis of TC11 titanium alloy at different temperatures[J].Transactions of Materials and Heat Treatment，2019，40(8): 61-68.

[7] WU J J，SHEN M L，CHENG Y X，et al.High power arc ion plating of thick Cr2 N hard coating on Ti-based alloys:Oxidation and wear behaviors[J].Surface and Coatings Technology，2022，448: 128924.

[8] 隋欣梦，胡记，张林，等.钛合金表面抗高温氧化涂层的研究进展[J].表面技术，2020，49(10):21-38.SUI X M，HU J，ZHANG L，et al.Reseah Temperature Oxidation Resistance Coating on Titanium Alloy[J].Surface Technology，2020，49 (10): 21-38.

[9] KUMAR P，MAHOBIA G S，MANDAL S，et al.Enhanced corrosion resistance of the surface modified Ti-13Nb-13Zr alloy by ultrasonic shot peening[J].Corrosion Science，2021，189: 109597.

[10] RICHARD C，KOWANDY C，LANDOULSI J，et al.Corrosion and wear behavior of thermally sprayed nano ceramic coatings on commercially pure Titanium and Ti - 13Nb -13Zr substrates[J].International Journal of Refractory Metals and Hard Materials，2010，28 (1): 115-123.

[11] AO N，LIU D X，WANG S X，et al.Microstructure and Tribological Behavior of a TiO2/hBN Composite Ceramic Coating Formed via Micro-arc Oxidation of Ti-6Al-4V Alloy[J].Journal of Materials Science ＆ Technology，2016，32(10): 1 071-1 076.

[12] QIN J，SHI X T，LI H Y，et al.Performance and failure process of green recycling solutions for preparing high degradation resistance coating on biomedical magnesium alloys[J].Green Chemistry，2022，24: 8 113-8 130.

[13] 王亚明，邹永纯，王树棋，等.金属微弧氧化功能陶瓷涂层设计制备与使役性能研究进展[J].中国表面工程，2018，31(4):20-45.WANG Y M，ZOU Y C，WANG S Q，et al.Design，Fabrication and Performance of Multifuctional Ceramic Coatings Formed by Microarc Oxidation on Metals: a Critial Review[J].China Surface Engineering，2018，31 (4): 20-45.

[14] 郝国栋，苏爽月，郝春丽，等.钛合金微弧氧化抗高温氧化研究现状[J].辽宁石油化工大学学报，2021，41(2):21-26.HAO G D，SU S Y，HAO C L，et al.Research Status on High Temperature Oxidation of Micro-Arc Oxidation of Titanium Alloy[J].Journal of Liaoning Petrochemical University，2021，41 (2): 21-26.

[15] 谢凤宽，章浩，刘谦.钛合金微弧氧化膜层摩擦学性能的研究进展[J].材料保护，2022，55(5):167-178.XIE F K，ZHANG H，LIU Q.Research Progress of Tribological Properties of Titanium Alloy Micro - Arc Oxidation Coatings [J].Materials Protection，2022，55 ( 5):167-178.

[16] 董凯辉，宋影伟，韩恩厚.钛合金耐磨微弧氧化制备技术的研究进展[J].表面技术，2021，50(7):57-65.DONG K H，SONG Y W，HAN E H.Research Progress on the Preparation of Wear-resistant Micro-arc Oxidation Coatings on Titanium Alloys[J].Surface Technology，2021，50(7): 57-65.

[17] WANG S X，LIU X，YIN X L，et al.High-temperature oxidation behavior of Ti2 AlNb alloy with PEO/hBN composite coating at 1 000 ℃[J].Surface and Coatings Technology，2020，404: 126473.

[18] YANG Z H，ZHANG Z，CHEN Y N，et al.Controllable in situ fabrication of self-lubricating nanocomposite coating for light alloys[J].Scripta Materialia，2022，211: 114493.

[19] 丁智松，高巍，魏敬鹏，等.TaC 微粒对Ti-6Al-4V 合金微弧氧化层结构和性能的影响[J].物理学报，2022，71(2):331-339.DING Z S，GAO W，WEI J P，et al.Effects of TaC microparticles on structure and properties of micro-arc oxidation coating on Ti-6Al-4V alloy[J].Acta Physica Sinica，2022，71(2): 331-339.

[20] FATTAH-ALHOSSEINI A，MOLAEI M，BABAEI K.The effects of nano- and micro-particles on properties of plasma electrolytic oxidation (PEO) coatings applied on titanium substrates: A review[J].Surfaces and Interfaces，2020，21: 100659.

[21] LI Z Y，CAI Z B，CUI X J，et al.Influence of nanoparticle additions on structure and fretting corrosion behavior of micro-arc oxidation coatings on zirconium alloy[J].Surface and Coatings Technology，2021，410: 126949.

[22] 高巍，刘江南，魏敬鹏，等.TC4 钛合金表面氧化亚铜掺杂微弧氧化层的结构和性能[J].材料研究学报，2022，36(6):409-415.GAO W，LIU J N，WEI J P，et al.Structure and Properties of Cu2O Doped Micro Arc Oxidation Coating on TC4 Titanium Alloy[J].Chinese Journal of Materials Research，2022，36 (6): 409-415.

[23] 刘建，朱新河，马春生，等.稀土添加剂对微弧氧化膜层影响的研究进展[J].稀有金属，2022，46(8):1 073-1 082.LIU J，ZHU X H，MA C S，et al.Research Progress on Micro-Arc Oxide Film with Rare Earth Additives[J].Chinese Journal of Rare Metals，2022，46 (8): 1 073-1 082.

[24] ATAPOUR M，BLAWERT C，ZHELUDKEVICH M L.The wear characteristics of CeO2 containing nanocomposite coating made by aluminate-based PEO on AM 50 magnesium alloy[J].Surface and Coatings Technology，2019，357:626-637.

[25] 胡杰，赵月，陶业成，等.氧化钕对2A12 铝合金微弧氧化膜层性能的影响[J].材料保护，2022，55(3):73-80.HU J，ZHAO Y，TAO Y C，et al.Effect of Neodymium Oxide on Properties of Micro-Arc Oxidation Coating Formed on 2A12 Aluminum Alloy[J].Materials Protection，2022，55(3): 73-80.

[26] 李鑫，张晟豪，王子恒，等.稀土氧化钇对AZ31B 镁合金微弧氧化膜层微观组织和性能的影响[J].材料保护，2022，55(10):37-42.LI X，ZHANG S H，WANG Z H，et al.Effect of Rare Earth Y2O3 on the Microstructure and Properties of AZ31B Magnesium Alloy Coatings Prepared by Micro-Arc Oxidation[J].Materials Protection，2022，55 (10): 37-42.

[27] ALIOFKHAZRAEI M，GHARABAGH R S，TEIMOURI M，et al.Ceria embedded nanocomposite coating fabricated by plasma electrolytic oxidation on titanium[J].Journal of Alloys and Compounds，2016，685: 376-383.

[28] FAZEL M，SHAMANIAN M，SALIMIJAZI H R.Enhanced corrosion and tribocorrosion behavior of Ti6Al4V alloy by auto-sealed micro-arc oxidation layers[J].Biotribology，2020，23: 100131.

Options

Outlines

模态框（Modal）标题

Abstract

Cite this article

References