Today is Email Alert  RSS

Effects of Power Modes on Properties of Micro-Arc Oxidation Biological Coatings on Magnesium Alloy

Expand
  • 1.School of Materials Science and Engineering,Jiangsu University of Science and Technology,Zhenjiang 212003,China;2.Zhejiang SANY Equipment Co.,Ltd.,Huzhou 313028,China;3.Department of Material Science and Technology of Metals,Admiral Makarov National University of Shipbuilding Institute,Nikolaev 54025,Ukraine

Received date: 2023-02-16

  Revised date: 2023-03-12

  Accepted date: 2023-04-15

  Online published: 2023-08-25

Abstract

At present,there are few studies on the preparation of biological coatings by micro-arc oxidation under different power modes.In this work,micro-arc oxidation (MAO) process was carried out on the surface of ZK60 magnesium alloy to prepare the biological coatings by means of four different power modes (full stage constant voltage mode,full stage constant current mode,constant voltage-constant current mode,constant current-constant voltage mode).The changes of voltage/current with time in the reaction process under different power supply modes were real-time recorded and analyzed,and the phase,microstructure,element distribution,surface roughness and contact angle of the MAO biological coatings obtained under different power supply modes were investigated by means of scanning electron microscope (SEM),energy dispersive spectrometer (EDS),Diffractometer (XRD) and Confocal microscopy.Results indicated that the phase constituents of the coatings prepared under four power modes included Mg,MgO and calcium-phosphorus products such as Ca3(PO4)2.Under different power modes,the thickness and corrosion resistance of the coatings were correspondingly different.The thickness of coatings prepared under constant voltage mode was the smallest due to insufficient breakdown force in the later stage,which was much smaller than other coatings prepared under three different power modes.Therefore,the corresponding roughness was also the smallest.Under the constant current mode,part of the coatings fell off due to high energy in the later stage,which led to the poor quality of the corrosion resistance of the MAO coatings.In contrast,under constant voltage-constant current mode,the defects of single constant voltage and constant current modes could be avoided.Compared with other three ones,the coatings prepared under constant voltage-constant current mode had the characteristics of uniform and dense microstructure,with a large thickness of about 55 μm.The electrochemical test indicated that the MAO biological coating prepared under constant voltage-constant current mode had better corrosion resistance.At the same time,this mode had the lowest energy consumption,which met the requirements of energy saving and consumption reduction.In addition,the MAO coating prepared under the hybrid voltage-current mode had better bio-compatibility.

Cite this article

WANG Zexin, GU Junjie, QI Fang, CHEN Liangyu, YE Fei, ZHANG Zhengyi, MAKSYM Bobrov, LU Sheng . Effects of Power Modes on Properties of Micro-Arc Oxidation Biological Coatings on Magnesium Alloy[J]. Materials Protection, 2023 , 56(8) : 133 -142 . DOI: 10.16577/j.issn.1001-1560.2023.0197

References

[1] 张金龙.医用Ti-Mg 复合材料的微波烧结制备及表面微弧氧化改性研究[D].南昌:南昌航空大学,2019.ZHANG J L.Study on Microwave Sintering Preparation and Surface Microarc Oxidation Modification of Medical Ti Mg Composite Materials[D].Nanchang: Nanchang Hangkong University,2019.

[2] 康明阳.骨科用生物可降解镁合金材料研制及骨科相关生物学功能研究[D].长春:吉林大学,2018.KANG M Y.Development of Biodegradable Magnesium Alloy Materials for Orthopedics and Research on Biological Functions Related to Orthopedics[D].Changchun: Jilin University,2018.

[3] ZHENG Y K,LAI L M,LIU W W,et al.Recent advances in biomedical applications of fluorescent gold nanoclusters[J].Advances in Colloid and Interface Science,2017(242): 1-16.

[4] 曾荣昌,孔令鸿,陈 君,等.医用镁合金表面改性研究进展[J].中国有色金属学报,2011,21(1): 35-41.ZENG R C,KONG L H,CHEN J,et al.Research progress in surface modification of medical magnesium alloys[J].Transactions of Nonferrous Metals Society of China,2011,21(1): 35-41.

[5] CHEN J F,LIN W X,LIANG S Y,et al.Effect of alloycations on corrosion resistance of LDH/MAO coating on magnesium alloys[J].Applied Surface Science,2019(463):535-544.

[6] ARGUETA-FIGUEROA L,MARTíNEZ-ALVAREZ O,SANTOS-CRUZ J,et al.Nanomaterials made of non-toxic metallic sulfides: A systematic review of their potential biomedical applications[J].Materials Science & Engineering C,2017(76): 1 305-1 315.

[7] ATAEE A,LI Y,SONG G S,et al.Metal scaffolds processed by electron beam melting for biomedical applications[M].[S.l.]:Metallic Foam Bone,2017: 83-110.

[8] GU X N,LI S S,LI X M,et al.Magnesium based degradable biomaterials: A review[J].Frontiers of Materials Science,2014,8(3): 200-218.

[9] USMAN B J,SCENINI F,CURIONI M.Exploring the use of an AC-DC-AC technique for the accelerated evaluation of anticorrosion performance of anodic films on aluminium alloys[J].Progress in Organic Coatings,2020 (144):105648.

[10] WU X,SU P,JIANG Z,et al.Influences of Current Density on Tribological Characteristics of Ceramic Coatings on ZK60 Mg Alloy by Plasma Electrolytic Oxidation[J].ACS Applied Materials & Interfaces,2010,2(3): 808-812.

[11] ZHAO D,CHEN J,REN Z,et al.Thermoelectric transport and magnetoresistance of electrochemical deposited Bi2Te3films at micrometer thickness[J].Ceramics International,2019,46(3):1-6.

[12] 芦 笙,付 丽,陈 静.镁合金热喷涂研究进展[J].江苏科技大学学报(自然科学版),2010,24(3):249-254.LU S,FU L,CHEN J.Research progress in thermal spraying of magnesium alloys[J].Journal of Jiangsu University of Science and Technology (Natural Science Edition),2010,24(3): 249-254.

[13] 曹 晖.基于微弧氧化/阴极沉积Mg(OH)2膜层的镁合金疏水表面改性技术研究[D].广州:华南理工大学,2019.CAO H.Research on Hydrophobic Surface Modification Technology of Magnesium Alloy Based on Micro Arc Oxidation/Cathodic Deposition of Mg (OH) 2Film Layer[D].Guangzhou: South China University of Technology,2019.

[14] 姚 巍.恒压-恒流模式超声辅助ZK60 镁合金微弧氧化生物膜层性能研究[D].镇江:江苏科技大学.2018.YAO W.Study on the Properties of Microarc Oxidation Biofilm on ZK60 Magnesium Alloy Assisted under Constant Voltage-Constant Current Mode by Ultrasound[D].Zhenjiang: Jiangsu University of Science and Technology,2018.

[15] 杨 威,赵玉峰,杨世彦.微弧氧化电源特性和参数对膜层性能及电能消耗的影响[J].材料工程,2010(2):86-90.YANG W,ZHAO Y F,YANG S Y.The Influence of Characteristics and Parameters of Micro Arc Oxidation Power Supply on the Film Performance and Energy Consumption[J].Journal of Materials Engineering,2010(2): 86-90.

[16] 王泽鑫.ZK60 镁合金微弧氧化复合电解液工艺及膜层组织和性能研究[D].镇江:江苏科技大学,2011.WANG Z X.Study on the Process,Film Structure and Properties of Microarc Oxidation Composite Electrolyte for ZK60 Magnesium Alloy[D].Zhenjiang: Jiangsu University of Science and Technology,2011.

[17] ZOU B.Effect of power frequency on the properties of AZ91D magnesium alloy ceramic layer by micro arc oxidation [J].Transactions of Nonferrous Metals Society of China,2015,25(5): 1 500-1 505.

[18] 陈 宏,郝建民.AZ91D 压铸镁合金微弧氧化的工艺研究[J].铸造技术,2009,30(5): 657-660.CHEN H,HAO J M.Study of the technics of micro-arc oxidation for AZ91D die-casting magnesium alloys[J].Foundry Technology,2009,30(5): 657-660.

[19] 刘思勤,齐玉明,彭振军,等.不同电解液中镁合金微弧氧化膜生长过程及腐蚀防护性能[J].硅酸盐学报,2021,49(6): 1 213-1 221.LIU S Q,QI Y M,PENG Z J,et al.Growth process and corrosion protection performance of micro arc oxidation film on magnesium alloy in different electrolytes[J].Journal of the Chinese Ceramic Society.2021,49(6): 1 213-1 221.

[20] 许 蕾.镁合金MAO 生物陶瓷膜成膜过程及体外降解特性研究[D].镇江:江苏科技大学,2015.XU L.Study on the Formation Process and Degradation Characteristics of Magnesium Alloy MAO Bio Ceramic membrane in Vitro[D].Zhenjiang: Jiangsu University of Science and Technology,2015.

[21] 郭佳奇.电参数和Na2WO4浓度对ZM6 微弧氧化膜组织和性能的影响[D].哈尔滨:哈尔滨理工大学,2020.GUO J Q.Effects of Electrical Parameters and Na2WO4Concentration on the Structure and Properties of ZM6 Micro Arc Oxidation Film[D].Haerbin: Harbin University of Science and Technology,2020.

[22] 王 猛.基于DSP 控制的微弧氧化脉冲电源设计[D].广州:广东工业大学,2015.WANG M.Design of Micro Arc Oxidation Pulse Power Supply Based on DSP Control[D].Guangzhou: Guangdong University of Technology,2015.

[23] 王迎军,刘康时.生物医用材料的研究与发展[J].中国陶瓷,1998,34(5): 26-29.WANG Y J,LIU K S.Research and Development of Biomedical Materials[J].China Ceramics,1998,34(5):26-29.

[24] 张广生.电源模式对ADC12 高硅铝合金微弧氧化膜层组织与性能的影响[J].装备环境工程,2020,17(8):97-103.ZHANG G S.Effect of power mode on the microstructure and properties of micro arc oxidation film on ADC12 high silicon aluminum alloy[J].Equipment Environmental Engineering,2020,17(8): 97-103.

[27] COHEN J.Current concepts review.Corrosion of metalorthopaedic implants[J].Journal of Bone & Joint Surgery American Volume,1998,80(10): 1 554.

[28] NAGELS J,STOKDIJK M,ROZING P M.Stress shielding and bone resorption in shoulder arthroplasty[J].Journal of Shoulder & Elbow Surgery,2003,12(1): 35-39.

[29] WANG B,HUANG P,OU C W,et al.In vitro corrosion and cytocompatibility of ZK60 magnesium alloy coated with hydroxyapatite by a simple chemical conversion process for orthopedic applications[J].International Journal of Molecular Sciences,2013,14(12): 23 614-23 628.

[30] CHOY J H,CHOI S J,OH J M,et al.Clay minerals and layered double hydroxides for novel biological applications[J].Applied Clay Science,2007,36(1): 122-132.

[31] DEL ARCO M,CEBADERA E,GUTIERREZ S,et al.Mg/Al layered double hydroxides with intercalated indomethacin: synthesis,characterization,and pharmacological study[J].Journal of Pharmaceutical Sciences,2004,93(6): 1 649-1 658.
Outlines

/