Preparation and Comprehensive Protective Performance Study of Thickened Magnolol Epoxy Resin Coatings

LI Zhu, HUANG Lu, HAN Fei, AN Ran, GUO Xiaoping, LIU Shuan

doi:10.16577/j.issn.1001-1560.2024.0057

Materials Protection >

2024 , Vol. 57 >Issue 3: 70 - 79

DOI: https://doi.org/10.16577/j.issn.1001-1560.2024.0057

Preparation and Comprehensive Protective Performance Study of Thickened Magnolol Epoxy Resin Coatings

Expand

(1. School of Materials Science and Chemical Engineering, Ningbo University, Ningbo 315211, China;
2. Key Laboratory of Marine Materials and Related Technologies, Zhejiang Key Laboratory of Marine Materials and Protective Technologies,
Ningbo Institute of Materials Technology and Engineering, Chinese Academy of Sciences, Ningbo 315201, China;
3. Hangzhou Benchuang Technology Co., Ltd., Hangzhou 310030, China)

LIU Shuan (1986-), Ph.D., Senior Engineer, Research Focus: Marine Heavy-Duty Anti-corrosion Coatings, E-mail: liushuan@nimte.ac.cn

Received date: 2023-06-12

Revised date: 2023-08-14

Accepted date: 2023-09-14

Online published: 2024-03-19

Supported by

National Key R&D Program Project (2023YFC2809901); Technology Project of Hangzhou Benchuang Technology Company; Open Project of the Key Laboratory of Marine New Materials and Application Technology, Chinese Academy of Sciences

Fold

Abstract

The biomass raw material magnolol with a biphenyl structure was used to synthesize bio-based epoxy resin, and flexible polyetheramine curing agents(D230, D400, D2000 and T403) were used to cure the bio-based epoxy anti-erosion coating. The effects of polyetheramine molecular weight and functionality on the mechanical properties, corrosion resistance and anti-erosion protection performance of magnolol epoxy resin were explored, and the anti-erosion mechanism of magnolol epoxy coatings was proposed. Results showed that the magnolol epoxy coating cured with D230 maintained a high impedance value(1.25×10¹¹ Ω·cm²) after 15 d of immersion in 3.5%(mass fraction) NaCl solution. The coating cured with T403 possessed a high tensile strength(26.59 MPa), low friction coefficient(0.373) and wear rate [0.018 3 mm³/(N·m)], while the magnolol epoxy coating cured with D2000 exhibited lower mass loss(244.74 mg) and volume loss(157 mm³) in the erosion test. Under the coupled erosion of solid/liquid/gas three-phase flow, the longer flexible segment of D2000 endowed the magnolol epoxy coating with better elasticity and flexibility, and therefore reduced the impact of the erosion medium, thus showing excellent anti-erosion performance.

Key words： thickened magnolol epoxy resin; polyether amine curing agents; mechanical properties; anti-erosion protection performance

Cite this article

LI Zhu, HUANG Lu, HAN Fei, AN Ran, GUO Xiaoping, LIU Shuan . Preparation and Comprehensive Protective Performance Study of Thickened Magnolol Epoxy Resin Coatings[J]. Materials Protection, 2024 , 57(3) : 70 -79 . DOI: 10.16577/j.issn.1001-1560.2024.0057

Options

Outlines

模态框（Modal）标题

Abstract

Cite this article